How to Replace the Battery in the Jabra Engage 75

Note: We don’t carry this headset or its battery, so our knowledge on it is limited to the content of this article. Hope this gets you what you need!

Yes, it is possible to replace this battery, but it can be a bit tricky! Here's how to do it:

1. Remove the earpad by just pulling on it until it pops out
2. Under the earpad, on the side, there is a little tab with a tiny '1' on it (circled below in yellow). Push this in and rotate the speaker clockwise slightly. After a couple millimeters, you will be able to pull one side of the speaker up on a hinge

   

3. Next, press in on the '2' tab at the bottom of the headset and pull up, then pull out. This releases the battery. The last picture below is what it looks like without the battery in

   

4. Put in the new battery and click into place using the 2 tab
5. Close the hinged battery door and rotate it counter-clockwise to click it shut until the 1 tab pops up
6. Snap the earpad back in, with the arrows pointing up towards the headband/top of the headset

   

You should now be good to go!

Think It’s Time For A New Headset? Many Jabra Customers have upgraded to the Leitner LH670.