Updated by Hayden Everly on Feb 10, 2023
Dislaimer: We no longer sell this headset, thus do not have much information on it aside from what is already in this article.
Sennheiser makes some great headsets, but even the best need some help from time to time. Read on to find some solid methods of fixing up some of the things that can happen!
(1) No sound on the headset.
(2) One party can hear well, but the other party cannot.
(3) The quality of sound is unsatisfactory.
A good starting point to correct these would be to check the compatibility switch underneath the base. The dial toggles from “A” to “C” and on most phone systems works best on “A”
If you’re experiencing an echo with the SD Pro, or find that people say you too soft or too loud, then adjusting the microphone volume will usually correct this. To adjust the volume, turn the white microphone volume underneath the charging base to the desired volume.
If the SD PRO isn’t working at all (i.e. dead air, static, etc.) it is usually good to start with a basic reset:
(1) Take the headset out of the charging base.
(2) Unplug the power adapter cord from the bottom of the base.
(3) Place headset on the charging base.
(4) Plug in the power adapter cord.
If the above reset does not correct the headset you can further the reset procedure between steps (2) and (3) by removing the battery from the headset.
1) With the headset in the base, remove the AC/DC power cord from the back of the base (under the yellow label)
Note: if the USB cord (under orange label) is being used, unplug that as well.
2) Move all 6 white Dip Switches DOWN located on the back of the base next to the power cord
3) Plug the AC/DC cord back into the base
4) Wait for 20 seconds, and then put all dip switches in the UP position and then put # 5 back down
5) Now wait for 1 minute or until blue light on headset appears and then test the headset
Note: if there’s already a microphone paired to the base, make sure it is turned off before syncing a new one otherwise it will conference the two.
1) Remove the headset from the charging cube
2) Press and hold the mute and call control buttons until the headset flashes red and blue
3) Put the headset back into the base. The light on the headset will turn blue when the pairing is complete
Time for a new headset?
Many Sennheiser users have switched to the Leitner LH370!
This is the internal support database for Headsets.com. We market office headsets in North America. With over 25 years experience in the business, we know headsets.
Please use our support database for free headset support, whether you’re a Customers of ours or not. If you have problems, suggestions, or unanswered questions please email us at hello@headsets.com (compliments and gratitude also welcomed)
This is the internal support database for Headsets.com. We market office headsets in North America. With over 25 years experience in the business, we know headsets.
Please use our support database for free headset support, whether you’re a Customers of ours or not. If you have problems, suggestions, or unanswered questions please email us at hello@headsets.com (compliments and gratitude also welcomed)
Questions/comments?