Permanently Register a 2nd Leitner Headset to the Same Base

These instructions will work for both Premium Lite and Premium Plus Headsets

You would pair 2 headsets to 1 base permanently when you want to train and have the ability to turn either headset on/off throughout the day without disrupting the pairing process.

How to permanently pair:

1. Begin with both headsets turned off and out of their bases.
2. Press and hold the microphone volume Up button for about 5 seconds (underneath the base) until the phone light on the base begins flashing, then let go.
3. On the 2nd headset, press and hold the ON/OFF button for 5 seconds until the headset begins to flash, then let go.
4. When pairing Premium Lite to another Premium Lite: Sit the 2nd headset in the primary base for about 30 seconds.
   1. If pairing a Leitner Premium Lite to a Premium Plus base, or pairing two Premium Plus headsets, you don't need this part)
      • The phone light will go solid and the headset light will stop flashing
      • The 2nd headset will now be registered to the base

This has been tested and both Headset A and Headset B will have call control!

Please note that the 2nd headset may not show battery lights on its original base when permanently paired. This is because it is only sending information to the 1st headset’s base.

To pair an LH200/300 series back to its base:

1. Begin with headset turned off and out of the charging base.
2. Unplug the handset lifter (if you have one of course).
3. Hold down the phone button on the base until the light next to it blinks.
4. Hold down the MUTE button on the headset until the light on the headset starts to blink.
5. Place the headset NEXT to the base (not in the base) and wait for phone light to go solid.

To pair an LH500/600 series back to its base:

Simply put the headset back in its original charging base and it will automatically sync right back up!