Leitner EHS Setup for Sangoma (Digium) Phones

Leitner wireless headsets are 100% compatible with the Sangoma HC01 Electronic Hookswitch (EHS) cable! To install, just follow the easy steps below!

Sangoma HC01 Electronic Hookswitch Setup in Phone Settings

1. Navigate to Menu --> Preferences --> Call Answering
2. Set Headset Answer to On
3. Set Electronic Hookswitch to Auto
4. Set Ring Headset Only to No

Leitner Headset Setup for HC01

1. Flip over the headset base and set the RHL/DHSG switch to DHSG. Make sure the compatibility switch (slide with numbers) is at 1
2. Plug included telephone cord with green sticker into the back of the headset base in the green phone port, then the other end into the headset port of your Sangoma phone
3. Take the Sangoma HC01 EHS and connect the square-shaped RJ45 size end to AUX jack in the Leitner base (the larger jack with silver around it), then plug the 5-pin end into the corresponding 5-pin jack in the phone

Compatible with the following phones:

• Digium D60
• Digium D62
• Digium D65
• Digium D80
• Sangoma D60
• Sangoma D62
• Sangoma D65
• Sangoma D70
• Sangoma D80
• Sangoma P310
• Sangoma P315
• Sangoma P320
• Sangoma P325
• Sangoma P330
• Sangoma P370