Leitner EHS Setup for 101Voice IP Phones

101Voice phones use the Leitner EHS for Grandstream and Ooma phones. This article goes over how to set it up with your 101Voice phone and which Leitner wireless headsets are compatible with this EHS cable.

Headset Setup:

1. Set the headset to DHSG and 1 on the bottom of the base
   

   

2. Connect the smaller RJ9 side of the EHS y-cord into the GREEN phone port in the back of the headset base (second from the right)
3. Connect the larger RJ45 jack of the y-cord into the AUX jack in the back of the headset base
4. Connect the last jack on the EHS y-cord into the HEADSET JACK on the back of your phone
   

   

Phone Settings:

101Voice Phones are shipped with EHS enabled by default. To enable ring detection, do the following:

1. Navigate to Menu
2. Select Features
3. Select General
4. Set Ring from Headset to either "Enable" (only rings on headset) or "Group Ring" (rings on headset and phone)

If the headset isn't answering/ending calls after these steps, email techsupport@101voice.com to request EHS be enabled

Phone Web Portal:

You most likely won't need to go into your phone's web portal, but if you do, this is the setting you want to get ring detection in your headset. If you don't have access to this web portal, you can contact your admin or IT team for help.

Note: The color scheme and branding may be different, but the menu options will be the same!

Once you get this done, you should get remote answering!

Compatible Leitner Headsets

This EHS will provide remote answering for specific Leitner headset models with the following serial numbers:

• Premium Lite headsets (LH200 & LH300 series) with an E in the serial number (ex: 23E4243007)
• Premium Plus headsets (LH500 & LH600 series) with OA in the serial number (ex: 23OA0178008)